LTCast LTCast
/ Importing a video
Manual › Importing a video

Importing a video

Video Reference keeps a video file synchronized to the audio for confirmation monitoring. This is useful when your show includes video playback and you want to see what the audience sees on screen while LTCast runs timecode.

Importing a file

Load a song first: the import needs audio to align against, so File → Import Video is greyed out until a song is loaded. Then choose it, or click the import button in the Video Audio row under the waveform. When the song has no video yet, that row is a dashed strip with an Import Video button in it. A file picker opens; it lists .mp4, .mov, .mkv, .avi, .webm, .mxf and .ts files.

The video appears in the Video Reference panel straight away. In the background LTCast reads the video's audio (Extracting audio...) and shows it as a green Video Audio lane under the music waveform. It compares that audio with the loaded song to work out how the two line up.

The sound is read with FFmpeg, but the picture in the preview is played by the app's built-in video player, which cannot play every codec. If it cannot play your file, the panel says Can't preview this file. Convert it to H.264 MP4. and offers Relink video…. A video that has no audio track still loads and plays as picture only (This video has no audio track). It has no waveform to align against, so it gets a Video (no sound) row instead: drag the clip along the lane, nudge it with ◀ ▶, or press Start at playhead to put its first frame where the playhead is.

Auto-alignment

After import, LTCast looks for the video's audio in the song, by where the sound jumps, so a phone recording in a room or a different master can still be found. The video may be shorter than the song or longer than it: a recording of a whole run with the song somewhere inside lands with its start before the song. If the music repeats or there is too little to go on, it says so and you should check the position; if the audio does not fit at all, the video goes to 0:00 and it says that too; fine-tuning is available with the frame nudge buttons (see Frame nudge) or by dragging the lane (see Aligning video to audio).

Per-song memory

The video file is remembered per-song. When you switch to a different song in the setlist, LTCast automatically loads the video assigned to that song and clears the preview if the new song has no assignment. See Per-song video memory for details.

Sound and output

The preview is silent by default and only follows the playhead: it never drives the clock, and nothing it does reaches LTC, MTC or any other output. In the Video Audio row three buttons choose what you hear:

  • Mute — the default; the video is silent.
  • Both — the video's own sound plays in the preview alongside the music, so you can compare the two. A volume slider appears.
  • Solo — only the video's sound is heard: the music output is silenced until you leave Solo. LTC and the other timecode outputs are not affected.

The mode goes back to Mute every time you switch songs, so Solo cannot carry its silenced music over into the next song. The video's sound comes from the preview in the main window, so you hear it only while that preview is shown (see Hide / show preview); the pop-out window is always silent.

Video Reference is a visual confirmation tool. It does not control the video playback system — it only follows along so you can verify sync visually.