Aligning video to audio
When you import a video, LTCast automatically aligns it by looking for the video's audio track in the loaded song. The result is an offset that tells LTCast where the video start sits relative to the audio.
Auto-alignment
Auto-alignment runs right after import. LTCast tries the video's audio at every position against the song, comparing where the sound jumps rather than how loud it is, so a phone recording in a room or a different master can still be found. When a position stands out, the offset is applied. If the music repeats or there is little to go on, the offset is still applied and LTCast says Placed where the audio fits best, but it could fit elsewhere too. Check it against the music. When it is not, LTCast places the video at 0:00 and says Audio does not match the video well — placed at 0:00; that happens when the video's audio and the song share too little content. In that case, align it by hand.
The video can be longer than the song. A recording of a whole run with the song somewhere inside it lands with its start before the song, as a negative offset, and the lane header then shows no Start TC.
To run the comparison again, click the ⟳ button (Re-sync to audio) in the Video Audio row.
Seeing and setting the alignment
There is no comparison dialog after import. The alignment is shown in the green Video Audio lane under the music waveform: the video's audio sits against the music, so you can see whether the loud moments line up. When the song contains LTC, the lane header shows Start TC, the timecode at the point where the video starts. The offset itself is shown as a small number such as +1.20s at the bottom of the Video Reference panel; it is a display, not a field you can type into.
To align by hand, drag the Video Audio lane left or right until its waveform lines up with the music above it. The start of the video snaps to a nearby Song Map section, and a dashed amber line marks the section. Each drag is one step of Ctrl+Z.
A clip with no sound
A video with no audio track has no waveform to compare, so auto-alignment does not run and there is no ⟳ button. LTCast says so once when you import it (This video has no audio track), places the clip at 0:00, and gives the song a Video (no sound) row instead of the Video Audio lane.
In that row the clip is a block on the song's timeline with its file name on it. The row's header shows where the clip starts and where the playhead is, for example Starts 00:12.05 · Playhead 01:03.10. There are three ways to place the clip:
- Drag the block along the lane. Its start snaps to a nearby Song Map section, as on the Video Audio lane. Each drag is one step of
Ctrl+Z. - ◀ and ▶ move it one frame at a time. See Frame nudge.
- Start at playhead puts the clip's first frame where the playhead is. Clicking the lane beside the clip moves the playhead, so you can click a spot and then press the button. Each press is one step of
Ctrl+Z.
The row has no Mute, Both or Solo buttons, because there is no sound to choose. The offset at the bottom of the Video Reference panel works as it does for any other video.
If the file is missing or cannot be opened, or LTCast cannot read the clip's length, there is nothing to place. You get the line This song has a reference video, but no audio waveform, with the ✕ to remove the video.
Frame nudge
For precision fine-tuning after auto-align or manual adjustment, use the ◀ and ▶ buttons in the Video Audio row. See Frame nudge for details. The offset changes by exactly one frame per press, at the project's current frame rate.